If installing on plaster or wallboard where possible pick up timber stud. If unable to locate stud, use a suitable wall plug or toggle for plasterboard to hold the brackets.
Face Fit

1. Attach brackets onto fixing surface 20mm lower than the position measure to the top
of the blind. The end brackets should be approximately 100mm from each end with additional brackets spaced evenly in-between. Make sure the spacing of the brackets does not interfere with the head rail pulleys.

2. Place the blind onto the top of the bracket and attach with a screw vertically up into the head board of the blind.
Top fixing

1. Pre-drill holes into the head rail of the blind. Drill the end holes approximately 100mm from each end. Drill further holes in-between approximately 300mm apart.

2. Screw up through the head rail into the top of the reveal or recess. Make sure the screw or fixing being used is suitable for the surface being fitted to.

How to install the Cord Cleat